Membrane-electrode assembly (MEA) for Direct Methanol Fuel Cell (DMFC)

BCS Fuel Cells, Inc. has introduced high performing membrane electrode assemblies (MEAs) for Direct Methanol Fuel Cell (DMFC) applications.  MEAs are available in the 3-layer format with membranes of choice and in various sizes and geometries. Operations are facilitated at higher temperatures without humidification of the air stream. 

The table below gives sample data from single cells of electrode area 25 cm2 with Nafion 117 membrane and 2.5% methanol solution. 

Anode  (Pt/Ru)	Cathode  (Pt)	T (oC)	Air pressure psig	Performance (mV)
				100 mA/cm2	200 mA/cm2
2 mg/cm2	2 mg/cm2	70	6	490	420
4 mg/cm2	2 mg/cm2	70	6	520	450

 The actual performance obtained by a customer will depend on proper choices of the various operating variables.

NEW PRODUCTS FROM BCS FUEL CELLS

• MEA for DMFC (Click here or on new products)

• Test Bench/ Demonstrator (Click here or on new products)

• 3W at 5V regulated system (Click here or on new products)

• 30W Convection Fuel Cell System (Click here or on new products)

• 60W Convection Fuel Cell System  (Click here or on new products)

• 100W Convection Fuel Cell System (Click here or on new products)

• 150W Convection Fuel Cell System (Click here or on new products)

• 150W Fuel Cell System (Click here or on new products)

• 300W Fuel Cell System (Click here or on new products)

• 500W Fuel Cell System (Click here or on new products)

• Uses and Applications (Click here or on new products)

• Control Unit for Fuel Cells (Click here or on new products)

• Air Control Unit for Fuel Cells (Click here or on new products

Additional Information